Dear Lily, Please see below and confirm if all the questions were clarified.
1) Inverted Pins
Please invert the pins as follows:
Inverted pins: 1 with 8; 2 with 7; 3 to 6; 4 to 5;
2) Mechanical weakness of the reel
We noted that the reel is weak and shipping and handling for placement on the board may cause it to break.
Please check the possibility of changing the reel
3) A layer of insulation tape has been added in the last winding, this raises the temperature of the copper and causes the yield of the component to fall.
Please remove insulation tape from the last winding
4) There was a very large variation in winding resistance at the 100kHz frequency, which causes a variation of Driver performance.
Please decrease electrical resistance of primary and secondary windings for increased performance
With a factory area of 33,000 square meters, construction area of 20,000 square meters, more than 100 sets main production equipments, our production capacity can be 30,000 ton per year.